Musical Fidelity Nu-Vista PAS Power Amplifier Black
2x300W stereo power amplifier on 8ohm in two chassis with separate power supply. 500W/1000W on 4/2ohm. Fully balanced. Input stage with 4 6S51N Nuvistors in balanced buffer configuration. Output stages with 5 transistor pairs. Central multifunction OLED display. XLR and RCA inputs. In/Out trigger. Separate power supply section with double toroidal transformers. Dimensions (WxHxD): 483x187.5x475mm stereo power amplifier and 483x187.5x475mm power supply. Weight: 27Kg stereo power amplifier and 40Kg power supply
Paypal, credit card, bank transfer
Buy new products, with original packaging and covered by warranty.
We offer you maximum availability by phone and by email.
We are always at your disposal, even after the purchase.
FEATURES
Amplifier
High power output, over 300W into 8 ohms, 500W into 4 ohms, 1000W peaks into 2 ohms
Output voltage: 49 Volts RMS
Output current: 130 Amps peak-to-peak
Damping factor: 200
Output devices: 5 pairs per channel
Gain: 16x (23.5 dB)
THD+N: < 0.003% typical, 20 Hz to 20 kHz
Signal-to-noise ratio: >108 dB 'A' weighted
Channel separation: >96 dB
Input impedance: 100 k Ohms
Input sensitivity for full output: 3 Volts RMS
Frequency response: +0, –1dB, 5Hz to 50 kHz
Input and Output
4 fully independent inputs: 2x RCA and 2x XLR
2 loop through outputs: 1x RCA and 1x XLR
Speaker outputs: 2 pairs of 4 mm banana plugs/binding posts
Trigger input and output: 3.5 mono jack socket mm
Trigger level ±5V to ±12V
General information
PAS weight: 27 kg net (35 kg)
PAS PSU weight: 40 kg net (50 kg)
PAS dimensions (WxHxD): 483 x 187.5 x 475 (494 with connectors)
PAS PSU dimensions (WxHxD): 483 x 187.5 x 475 (478 with connectors)
Mains voltages: 115/230VAC 50/60Hz (factory preset); 100VAC 50/60Hz (alternative)
Consumption <0.5 W in standby mode; 130 W on and off; 1060W maximum