Rotel RA-6000 Diamond Series Integrated Hi-Fi Stereo Amplifier - Black

RA-6000

The RA-6000 Diamond Series integrated amplifier celebrates 60 years of Rotel's Japanese heritage. The RA-6000 supports a wide range of modern and legacy analog and digital sources, delivering 350 watts of Class AB power into 4 ohms with exceptional acoustic detail and rich, deep bass.

The Rotel RA-6000 features Class AB power amplifier sections, capable of a whopping 350W per channel into 4 ohms and 200W into 8, but above all with an extremely high damping factor (600), which will allow it to drive any speaker, even very difficult ones, with great ease.

On board is a Texas Instruments 32-bit/384 kHz DAC with coaxial, optical, and USB-B inputs for PC/MAC with MQA support, aptX™, Roon certification, Bluetooth AAC streaming, while for the analog sector, balanced XLR, RCA, Phono MM and SUB output, for maximum versatility from every point of view. The RA-6000 uses a large toroidal transformer that powers 4 high efficiency, low ESR T-Network slit-foil capacitors, capable of providing all the energy needed for the best control at low frequencies. Separate branches for pre, digital and power sections, starting from the filtering stages and continuing into the leveling stages, and each one is separately regulated. A nice dot matrix display takes center stage, with input selection buttons below and a solid volume knob. A very elegant and backlit remote control is included.

TECHNICAL SPECIFICATIONS

Maximum power 4/8 ohm: 350/200W

Total harmonic distortion: <0.0075%

Intermodulation distortion: <0.03%

Frequency response: 10Hz-100kHz

Damping factor: 600

RCA/XLR line input sensitivity: 340/540 mV

RCA/XLR overload: 3.5/4.5 V

Pre-amplified output level/impedance: 109V/100 ohm

Signal to noise ratio: 103dB

Supported resolutions: up to 32/384

Power supply: 230V/50Hz

Standby/maximum consumption: <0.5/500 W

BTU: 1239 BTU/h

Dimensions (W×H×D): 431x144x425mm

Weight: 18.8 kg

Intermodulation distortion (60Hz:7kHz, 4:1) <0.03%

Damping factor 600

Input sensitivity

Line inputs (RCA): 340mV

Line inputs (XLR): 540mV

Digital Inputs: 0 dBfs

Phono Input (MM): 5.2mV

Input Impedance

Line Inputs (RCA): 5.6kΩ

Line Inputs (XLR): 100kΩ

Digital Inputs: 75Ω

Phono Input (MM): 47kΩ

Input Overload Level

Line Inputs (RCA): 3.5V

Line Inputs (XLR): 4.5V

Phono Input: 52mV

Pre-Amp Output Level 1.9V

Pre-Amp Output Impedance 100Ω

Input Formats Electrical/Optical LPCM (up to 24-bit/192kHz)

PC-USB

USB Audio Class 2.0 (up to 32-bit/384kHz)*

*Driver installation required MQA and MQA Studio (up to 24-bit/384kHz ) Roon Tested